201 County Road 432 • Englewood, TN 37329 • 1 877-249-5251 Toll Free • Lauren Gadd, Editor | Noel Jones, Creative Director
|
|---|
Insignia™ & Allegiant™ Organs
How to Save Memory Banks to a PR-300™ Sequencer
1. Start PR-300™ Recording
Press REC
Press TRACK 1
Press PLAY
Wait till Display Window in the PR or MR Count-in (-2, -1) finishes.
2. When PR-300™ Display Meaure number reads 1
On the Organ: HOLD SET and PRESS M1
Let go of both pistons
Organ Display Window will almost immediatly read: Memory Copied to Sequencer Port
3. To save this to PR-300™ Disk
Open the top lid of the PR-300™ and press SAVE
A number will appear on the PR-300™ screen.
Press ENTER to save the recorded Sequence to the Disk.Note:
You may choose a different number if this one is already in use (a : will follow the number)
You may also name this Sequence just like a Song for easy referenceFrequently Asked Questions:
What if I want to save more than one memory at a time?
Wait a few seconds after yoiu finish Step 3 and then go back to Step 2, pressing the new M Level you wish to save.
Do I need to format the Floppy Disk first in the PR-300™?
Yes, we recommend you format the floppy Disk first in the PR-300™ to guarantee a bit more reliability in file storage and management.
Reloading Memory Levels to the Organ from the PR-300™
1. Start PR-300™ Playing the Recorded Memory Level
Choose the Song Name
Press PLAY
2. When an Memory Level Piston on the Organ begins to Flash
Press STOP on the PR-300™
Hold SET and
Press the Flashing Organ Memory Level PistonThe Memory has been reloaded from the Disk
If you have saved more than one memory, press PLAY on the PR-300™ to load the next one.
Each M Level Piston will light as its information arrives. Hold SET and Press it to save.Frequently Asked Questions:
What if I want to save what was in M1 to M2?
When M1 flashes, which tells you it is ready to be loaded, press M2 to load there instead.